Revert "PCI: Don't scan random busses in pci_scan_bridge()"

This reverts commit fc1b253 ("PCI: Don't scan random busses in
pci_scan_bridge()") because it breaks CardBus on some machines.

David tested a Dell Latitude D505 that worked like this prior to
fc1b253:

    pci 0000:00:1e.0: PCI bridge to [bus 01]
    pci 0000:01:01.0: CardBus bridge to [bus 02-05]

Note that the 01:01.0 CardBus bridge has a bus number aperture of
[bus 02-05], but those buses are all outside the 00:1e.0 PCI bridge bus
number aperture, so accesses to buses 02-05 never reach CardBus.  This is
later patched up by yenta_fixup_parent_bridge(), which changes the
subordinate bus number of the 00:1e.0 PCI bridge:

    pci_bus 0000:01: Raising subordinate bus# of parent bus (#1) from #1 to #5

With fc1b253, pci_scan_bridge() fails immediately when it notices that
we can't allocate a valid secondary bus number for the CardBus bridge, and
CardBus doesn't work at all:

    pci 0000:01:01.0: can't allocate child bus 01 from [bus 01]

I'd prefer to fix this by integrating the yenta_fixup_parent_bridge() logic
into pci_scan_bridge() so we fix the bus number apertures up front.  But
I don't think we can do that before v3.17, so I'm going to revert this to
avoid the problem while we're working on the long-term fix.

Link: https://bugzilla.kernel.org/show_bug.cgi?id=83441
Link: http://lkml.kernel.org/r/[email protected]
Reported-by: David Henningsson <[email protected]>
Tested-by: David Henningsson <[email protected]>
Signed-off-by: Bjorn Helgaas <[email protected]>
CC: [email protected]	# v3.15+

Author: bjorn-helgaas

drivers/pci/probe.c

@@ -838,16 +838,12 @@ int pci_scan_bridge(struct pci_bus *bus, struct pci_dev *dev, int max, int pass)
 			goto out;
 		}
 
-		if (max >= bus->busn_res.end) {
-			dev_warn(&dev->dev, "can't allocate child bus %02x from %pR\n",
-				 max, &bus->busn_res);
-			goto out;
-		}
-
 		/* Clear errors */
 		pci_write_config_word(dev, PCI_STATUS, 0xffff);
 
-		/* The bus will already exist if we are rescanning */
+		/* Prevent assigning a bus number that already exists.
+		 * This can happen when a bridge is hot-plugged, so in
+		 * this case we only re-scan this bus. */
 		child = pci_find_bus(pci_domain_nr(bus), max+1);
 		if (!child) {
 			child = pci_add_new_bus(bus, dev, max+1);