This is a vik module to support the following joysticks:
Please note that this PCB does not support the click on the sparkfun analog joystick, only x and y movements
For PCB fabrication, you can use the files in the production folder.
- gerbers.zip - the file used to fabricate the pcb
- bom.csv - used for PCBA. You can also use the part numbers in this file to look up the exact parts as lcsc.com
- positions.csv - used for PCBA
Using the 3 files above, this has been tested at jlcpcb.com
| Category | Classification | Response |
|---|---|---|
| FPC connector | Required | ✔️ |
| Breakout pins | Recommended | ❌ |
| Uses: SPI | Optional | ❌ |
| SPI used for SPI only | Strongly recommended | N/A |
| Uses: I2C | Optional | ❌ |
| I2C used for I2C only | Strongly Recommended | ❌ |
| I2C pull ups | Required | N/A |
| Uses: RGB | Optional | ❌ |
| Uses: Extra GPIO 1 | Optional | ✔️ |
| Uses: Extra GPIO 2 | Optional | ✔️ |
| Standard PCB Size/Mount | Strongly recommended | ❌ |
Caution: I have not tested the joycon joystick, but I wired per the image below
I got this diagram from here:
https://sudomod.com/forum/viewtopic.php?t=3485
